Action Electronics

Switches

Home »  Switches

P104 SOUND SELECTOR SWITCH

Designed to fit onto P100 Noisy Thing and operate up to 8 General Sounds from a spare RC channel (when using P100 in Throttle mode). Supplied built with ABS cover and full instructions.

P43 SINGLE RELAY SWITCHER

Non-latching single circuit switch; 1 Amp continuous rating; suits sound simulators, small motors, relays etc. Can be operated from any type of Tx stick or switch. Size 41mm x 31mm x 20mm. Will handle voltage up to 24 Volts. Screwdriver connection.

P44A UNIVERSAL TWIN SWITCHER

Our most popular R/C switcher. PIC-based; 2 separate switched circuits from one proportional R/C channel. Each of the two outputs can be driven as either Latching (Memory) or Non-Latching (Momentary) switches. 2 different voltages can be switched. Will operate most of the auxiliary functions on a boat up to 3A per circuit, including one motor in both directions. Case size only 53.5mm x 37.5mm x 23mm. Screwdriver connection. NOT suitable for ON/OFF switched channels e.g. ‘Retract gear’

P62 QUADSWITCH

Up to 4 latching switch functions from one proportional channel. It is operated by quickly ‘jabbing’ the Tx stick and letting go immediately. 4 independent relays means you may use up to four different batteries (and voltages) if you need to. 1 Amp maximum load per Switch. Case size is 63 x 43 x 25mm, and connections are via screw-terminals. NOT suitable for ON/OFF switched channels e.g. ‘Retract gear’

P69 pico TWIN SWITCHER

PIC-based switch which provides two separate switched circuits from only one proportional R/C channel. Power for the loads comes directly from the receiver battery pack (4.8v to 6v). Each of the two outputs can be driven as either Latching (Memory) or Non-Latching (Momentary) switches; 300 mA (0.3A) max load per switch. For the control of micro-horn or micro-whistle, micro smoke generator, lights etc. Case size only 34mm x 24.5mm x 16mm. Simple solder connection to loads. NOT suitable for ON/OFF switched channels e.g. ‘Retract gear’

P91 HI-LOAD TWIN SWITCHER

PIC-based; 2 separate switched circuits from one proportional R/C channel. Each of the two outputs can be driven as either Latching (Memory) or Non-Latching (Momentary) switches. Adjustable switching points; 10Amps (peak 20A) on each circuit. Designed especially to operate motorised functions such as fire-monitors, bilge pumps and twin-motor bow-thrusters; will also switch ‘conventional’ loads such as lights and sound simulators. Case size is 63 x 43 x 25mm, and connections are via screw-terminals. Limited functionality when operated from ON/OFF switched channels – ring for details.